How to Use VMax

How to Use Electronic Cigarette VMax?

One of the greatest feature of VMax is: using only one button to access different menu functions through a series of clicks.

(Notes: the display should be in “off” state before you press the button every time.)

Function 1: Power Adjust Up

1. Press the button 3 times in a row when "1.Uu" is shown on the display .

2. Leave the button idle for 2 seconds. The display will change to show the last voltage selected.

3. Once the voltage is displayed, each time you press the button the voltage will advance to the next higher setting: 3.1,3.2,3.3 etc. When it reaches 6.0, it will be back to 3.0 and go up again.

4. when you reach the desired setting, leave the button idle for 2 seconds. The setting will be saved and VMax will resume normal operation.

Function 2: Power Adjust Down

1. Press the button 4 times in a row when "2.Ud" is shown on the display .

2. Leave the button idle for 2 seconds. The display will change to show the last voltage selected.

4. Once the voltage is displayed, each time you press the button the voltage will advance to the next lower setting: 5.9,5.8,5.7 etc. When you reach 3.0, it will be back to 6.0 and go down again.

4. when you reach the desired setting, leave the button idle for 2 seconds. The setting will be saved and VMax will resume normal operation.

Function 3: Power on/off

1. Press the button 5 times in a row until "3.So" is shown on the display .

2. Leave the button idle for 2 seconds. The display will show the last setting , “on” or “off”.

4. Each time you press the button the display will toggle between on/off

4. when you reach the desired setting, leave the button idle for 2 second. If you select "OF" the VMax will go into standby mode.

Function 4: Battery Check

1. Press the button 6 times in a row until “4.Uc” is shown on the display.

2. Leave the button idle for 2 seconds, the digital display will show your battery voltage measurement.

3. The battery voltage will be displayed for 2 seconds, then the display will automatically turn off.

Function 5: Atomizer Check

1. Press the button 7 times in a row when “5.dR” is shown on the display,

2. Leave the button idle for 2 seconds, then the setting will be saved and the display will show your atomizer resistance.

Function 6: LED ON/OFF

1. Press the button 8 times in a row when "6.Lo" is shown on the display.

2. Leave the button idle for 2 seconds, the display will show the current setting: ON/OFF .

3. Each time you press the button, the setting will toggle between on/off.

4. when you reach the desired setting, leave the button idle for 2 seconds. The setting will be saved and VMax will resume normal operation.

Other functions:

The display will show the below error code when there is short circuit:

1. F1: resistance of the cartomizer’s heating coil is bigger than 0.5R, or smaller than 1.3R

2. F2: resistance of the cartomizer’s heating coil is smaller then 0.5R

Suggested Cartomizer ohm:

3v-4v for 1.5 ohm

4v-5v for 2.0-2.5 ohm

5v-6v for 3.0 ohm